I decided to convert my Bo Staff to a Shaolin Monk Spade using the Cold Steel Special Forces Shovel I recently acquired.
NEWSLETTER: https://cahlen.org/subscribe
ODYSEE: https://odysee.com/@Cahlen:0
BITCHUTE: https://www.bitchute.com/channel/HMCvCO1WIFpj
HIVE: https://peakd.com/@cahlen
BRIGHTEON: https://www.brighteon.com/channels/cahlen
GAB: https://gab.com/CahlenLee
MINDS: https://www.minds.com/CahlenLee
TELEGRAM: https://t.me/CahlenLee
▶️ 3Speak
Nice, you could still put a spear at the end, but cut off enough of the staff to hollow out and cap over it? Then widdle the spear side down a bit to fit tight inside the cap and maybe add a set screw.
Sounds interesting, though I'm having a hard time imagining what you're describing.
If you use a 6" spearhead, cut 8" off the bottom of the staff. Drill a hole down the middle of the piece you cut off big enough to nestle the spear head into(connect the spearhead into the staff end). Of course, the spearhead would need to be thinner than the staff.
Carve out 2" at the bottom of the staff into a cone shape and match that shape to the spearhead cover side, so it nestles tightly. If tight enough, no set screw is needed and you can pop the cover off quickly if you need to. If you don't trust the cap to stay by itself, add a set screw about an inch up the cone connector area.
Hey @cahlen - btw my biz partner and I are just now being onboarded to OGWN -
Congratulations @cahlen! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s):
 | You distributed more than 53000 upvotes. Your next target is to reach 54000 upvotes. |
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word STOP
To support your work, I also upvoted your post!
Check out the last post from @hivebuzz:
 | Hive Power Up Month - Feedback from February day 22 |